DIR-300 Wireless N 150 Home Router
User Manual
Configuring via Web-based Interface
MAC Filter
On the Wi-Fi / MAC Filter page, you can define a set of MAC addresses of devices which will be
allowed to access the WLAN, or define MAC addresses of devices which will not be allowed to
access the WLAN.
Figure 93. The MAC filter for the wireless network.
By default, MAC filtering is not active (the Disabled value is selected from the MAC filter
restrict mode drop-down list on the Filter mode tab).
To open your wireless network for the devices which MAC addresses are specified on the MAC
addresses tab and to close the wireless network for all other devices, select the Allow value from
the MAC filter restrict mode drop-down list and click the Change button.
To close your wireless network for the devices which MAC addresses are specified on the MAC
addresses tab, select the Deny value from the MAC filter restrict mode drop-down list and
click the Change button.
To add a MAC address to which the selected filtering mode will be applied, proceed to the MAC
addresses tab.
Page 116 of 170
To Next Page
Loading...
