DIR-300 Wireless N 150 Home Router
User Manual
Configuring via Web-based Interface
NTP Client
On the System / NTP client page, you can manually set the time and date of the router or
configure automatic synchronization of the system time with a time server on the Internet.
Figure 124. The System / NTP client page.
To set the system time manually, select the Manual value from the Mode drop-down list and set
the time and date in the fields displayed. Then click the Change button.
To enable automatic synchronization with a time server, follow the next steps:
1. Select the NTP value from the Mode drop-down list.
2. Select your time zone from the drop-down list. To set the time zone in accordance with the
settings of your operating system, click the Determine timezone button in the bottom
right corner of the page.
3. Specify the needed NTP server in the NTP servers field or leave the server specified by
default.
4. Click the Change button.
!
When the router is powered off or rebooted, the system time is reset to the default value.
If you have set automatic synchronization for the system time, the internal clock of the
device will be configured after connecting to the Inter net. If you have set the system time
manually, you need to set the time and date again (see above).
Page 163 of 170
To Next Page
Loading...
