DIR-300 Wireless N 150 Home Router
User Manual
Installation and Connection
Figure 24. The top-page menu.
Click the Reboot line if you have already saved the router's settings.
Click the Save&Reboot line to save new settings and immediately reboot the router.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the router) to your PC. Also you can save the router's configuration to your PC via the Backup
button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware RESET button. The button is
located on the back panel of the router next to the power connector.
To restore the factory default settings, push the button (with the router powered on) and hold for 7
seconds. Then release the button. All LEDs of the router should turn off and then turn on again.
Wait for about 30 seconds. Now you can access the web-based interface of the router using the
default IP address, username and password.
When you have configured all needed settings, click the Logout line.
Page 35 of 170
To Next Page
Loading...
