D-Link DIR-605 - Configure WPA-PSK and WPA2-PSK

24
D-Link DIR-605 User Manual
Section 3 - Conguration
Select Static if your ISP assigned you the IP
address, subnet mask, gateway, and DNS server
addresses. In most cases, select Dynamic.
Enter the L2TP IP address supplied by your ISP
(Static only).
Enter the Subnet Mask supplied by your ISP
(Static only).
Enter the Gateway IP Address provided by your
ISP.
Enter the Server IP provided by your ISP
(optional).
Enter your L2TP username.
Enter your L2TP password and then retype the
password in the next box.
Select either Always-on, On-Demand, or Manual.
Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature,
enable Auto-reconnect.
Enter the Primary and Secondary DNS Server Addresses (Static L2TP only).
Address Mode:
L2TP IP Address:
L2TP Subnet Mask:
L2TP Gateway:
L2TP Server IP:
Username:
Password:
Reconnect Mode:
Maximum Idle Time:
DNS Servers:
L2TP
$IPPTF-51-BZFS5VOOFMJOH1SPUPDPM JG ZPVS*41VTFTB-51DPOOFDUJPO:PVS *41XJMMQSPWJEFZPV XJUIB
username and password. This option is typically used for DSL services.