D-Link DIR-605 - Configure WEP

55
D-Link DIR-605 User Manual
Section 3 - Conguration
Time Settings
Select the Time Zone from the drop-down
menu.
To select Daylight Saving time manually, select
enabled or disabled, and enter a start date and
an end date for daylight saving time.
Press this button to set the device’s time the same
to local PC.
NTP is short for Network Time Protocol. NTP
synchronizes computer clock times in a network
of computers. Check this box to use a NTP server.
This will only connect to a server on the Internet,
not a local server.
Enter the NTP server or select one from the drop-
down menu, then the DIR-605 will sync the same
time to D-Link Internet time server.
To manually input the time, enter the values in
UIFTFöFMETGPSUIF:FBS.POUI%BZ)PVS.JOVUF
and Second and then click Set Time.
Time Zone:
Daylight Saving:
Sync your
Computer’s Time
Settings:
Enable NTP
Server:
NTP Server Used:
Manual:
The Time Conguration option allows you to congure, update, and maintain the correct time on the internal system
clock. From this section you can set the time zone that you are in and set the Time Server. Daylight Saving can also
be congured to automatically adjust the time when needed.