D-Link DIR-605 - Configure WPA-Personal (PSK)

76
D-Link DIR-605 User Manual
Section 4 - Security
Congure WPA-Personal (PSK)
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
XJSFMFTTDPOOFDUJWJUZCFGPSFFOBCMJOH FODSZQUJPO:PVSXJSFMFTTTJHOBM NBZEFHSBEFXIFOFOBCMJOHFODSZQUJPO EVF UP
the added overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Setup and then click Wireless Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto, WPA2 Only, or WPA Only. Use
Auto if you have wireless clients using both WPA and WPA2.
4. Next to Cypher Type, select TKIP and AES, TKIP, or AES. If you have
wireless clients that use both types, use TKIP and AES.
5. Next to Group Key Update Interval, enter the amount of time before the group key used for broadcast and multicast data is
changed (3600 is default).
6. Next to Pre-Shared Key, enter a key (passphrase). The key is entered as a pass-phrase in ASCII format at both ends of the
wireless connection. The pass-phrase must be between 8-63 characters.
7. Click Save Settings to save your settings. If you are conguring the router with a wireless adapter, you will lose connectivity
until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the router.