D-Link DIR-605 - Access Control

32
D-Link DIR-605 User Manual
Section 3 - Conguration
Manual Wireless Network Setup
Check the box to enable the wireless function. If you do
not want to use wireless, uncheck the box to disable all
the wireless functions. Click Add New to create your own
time schedule to enable the wireless function.
Service Set Identier (SSID) is the name of your wireless
network. Create a name using up to 32 characters. The
SSID is case-sensitive.
Select one of the following:
802.11g Only - Select if all of your wireless clients are
802.11g.
Mixed 802.11g and 802.11b - Select if you are using
both 802.11b and 802.11g wireless clients.
802.11b Only - Select if all of your wireless clients are
802.11b.
802.11n Only - Select only if all of your wireless clients
are 802.11n.
Mixed 802.11n, 802.11b, and 802.11g - Select if you are
using a mix of 802.11n, 11g, and 11b wireless clients.
Mixed 802.11n and 802.11g - Select if you are using a
mix of 802.11n and 802.11g wireless clients.
The Auto Channel Scan setting can be selected to allow the DIR-605 to choose the channel with the least amount of interference.
Indicates the channel setting for the DIR-605. By default the channel is set to 6. The Channel can be changed to t the channel
setting for an existing wireless network or to customize the wireless network. If you enable Auto Channel Scan, this option will be
greyed out.
Select the transmit rate. It is strongly suggested to select Best (Auto) for best performance.
Select the Channel Width:
Enable Wireless:
Wireless Network
Name:
802.11 Mode:
Transmission Rate:
Enable Auto
Channel Scan:
Wireless Channel: