D-Link DIR-605 - Statically Assign an IP address

89
D-Link DIR-605 User Manual
Section 6 - Troubleshooting
:PVTIPVMETUBSU BU  BOE XPSLZPVSXBZ EPXOCZFBDIUJNF0ODFZPVHFUB SFQMZ HP VQ CZVOUJMZPVHFU B
fragmented packet. Take that value and add 28 to the value to account for the various TCP/IP headers. For example,
lets say that 1452 was the proper value, the actual MTU size would be 1480, which is the optimum for the network
we’re working with (1452+28=1480).
Once you nd your MTU, you can now congure your router with the proper MTU size.
To change the MTU rate on your router follow the steps below:
t0QFOZPVSCSPXTFSFOUFSUIF*1BEESFTTPGZPVSSPVUFSBOEDMJDLOK.
t&OUFSZPVSVTFSOBNF BENJOBOEQBTTXPSECMBOL CZEFGBVMU$MJDL OK to enter the web conguration
page for the device.
t$MJDLPOSetup and then click Manual Congure.
t5PDIBOHFUIF.56FOUFSUIFOVNCFSJOUIF.56öFMEBOEDMJDLSave Settings to save your settings.
t5FTUZPVSFNBJM *G DIBOHJOHUIF.56EPFTOPUSFTPMWFUIFQSPCMFNDPOUJOVF DIBOHJOHUIF.56JO
increments of ten.