D-Link DIR-655 - Qos Engine

57D-Link DIR-655 User Manual
Section 3 - Conguration
QoS Engine
This option is disabled by default. Enable this option for better performance
and experience with online games and other interactive applications, such
as VoIP.
This option is enabled by default when the QoS Engine option is enabled.
This option will allow your router to automatically determine the uplink
speed of your Internet connection.
This displays the detected uplink speed.
The speed at which data can be transferred from the router to your ISP. This
is determined by your ISP. ISP’s often note speed as a download/upload
pair. For example, 1.5Mbits/284Kbits. Using this example, you would enter
284. Alternatively you can test your uplink speed with a service such as
speedtest.net.
This option is disabled by default. Enable this option for better performance
and experience with online games and other interactive applications, such
as VoIP.
This option is enabled by default so that your router will automatically
determine which programs should have network priority. For best
performance, use the Automatic Classication
option to automatically set the priority for your applications.
This option should be enabled when you have a slow Internet uplink. It
helps to reduce the impact that large low priority network packets can
have on more urgent ones.
A QoS Engine rule identies a specic message ow and assigns a priority
to that ow. For most applications, automatic classication will be adequate
and specic QoS Engine rules will not be required.
The QoS Engine supports overlaps between rules, where more than one
rule can match for a specic message ow. If more than one rule is found
to match, the rule with the highest priority will be used.
Enable Trac Shaping:
Automatic Uplink
Speed:
Measured Uplink
Speed:
Manual Uplink Speed:
Enable QoS Engine:
Automatic
Classication:
Dynamic
Fragmentation:
QoS Engine Rules:
The QoS Engine helps improve your network gaming performance by prioritizing applications. By default, the QoS Engine settings are disabled and
application priority is not classied automatically.