D-Link DIR-655 - Page 74

70D-Link DIR-655 User Manual
Section 3 - Conguration
The wizard will either display the wireless network settings to guide you
through manual conguration, prompt you to enter the PIN for the device,
or ask you to press the conguration button on the device. If the device
supports Wi-Fi Protected Setup and has a conguration button, you can add
it to the network by pressing the conguration button on the device and
then the on the router within 60 seconds. The status LED on the router will
ash three times if the device has been successfully added to the network.
There are several ways to add a wireless device to your network. A “registrar”
controls access to the wireless network. A registrar only allows devices onto
the wireless network if you have entered the PIN, or pressed a special Wi-Fi
Protected Setup button on the device. The router acts as a registrar for the
network, although other devices may act as a registrar as well.
Click to start the Add Wireless Device wizard.
Add Wireless
Station:
Add Wireless Device
with WPS: