Input the IP address distributed to you.
Input the Netmask distributed to you.
Input the Gateway address distributed to you.
Set DNS domain postfix. When the domain which
you input cannot be parsed, phone will automatically
add this domain to the end of the domain which you
input before and parse it again.
Input your primary DNS server address.
Input your secondary DNS server address.
If you uses PPPoE mode， you need to make the above setting.
It will be provided by ISP.
Input your ADSL password.
Notice:
1) Click “Apply” button after finished your setting, IP Phone will save the
setting automatically and new setting will take effect.
2) If you modify the IP address, the web will not response by the old IP
address. Your need input new IP address in the address column to logon in
the phone.
3) If networks ID which is DHCP server distributed is same as network ID
which is used by LAN of system, system will use the DHCP IP to set WAN,
and modify LAN‟s networks ID (for example, system will change LAN IP
from 192.168.10.1 to 192.168.11.1) when system uses DHCP client to get IP
in startup; If system uses DHCP client to get IP in running status and
network ID is also same as LAN‟s, system will refuse to accept the IP to
configure WAN. So WAN‟s active IP will be 0.0.0.0.
8.3.2.2 Qos&VLAN
The VOIP phone support 802.1Q/P protocol and DiffServ configuration. VLAN
functionality can use different VLAN IDs by setting signal/voice VLAN and
data VLAN. The VLAN application of this phone is very flexible.
To Next Page
Loading...
