D-Link DSL-2740B User Manual

Section 3 - Configuration
D-Link DSL-2740B User Manual
54
ADD MAC FILTER
Select the Wireless Mac Filter Policy as Disabled to disable this filter
Select the Wireless Mac Filter Policy as Deny to filter out all wireless
MAC address besides the MAC addresses in the Wireless Mac Filter lists.
Select the Wireless Mac Filter Policy as Allow to filter out all wireless
MAC address in the Wireless Mac Filter lists.
Enter the Wireless MAC Address. Click on the Save/Apply button to add
in the wireless MAC filter list.
This page allows you to configure wireless bridge features of the wireless
LAN interface. You can select Wireless Bridge (also known as Wireless
Distribution System) to disables access point functionality.
Select Enabled from the Bridge Restrict and enter the peer AP MAC
address(es); or select Enabled (Scan) to find the available APs for you to
choose.
Click "Refresh" to update the remote bridges. Wait for few seconds to
update.
Click "Apply" to configure the wireless bridge options.
Note: Wireless Bridge only works on 11b/g mode. Only the APs operating
in the same channel can be bridged.

D-Link DSL-2740B Specifications

ADSL Standards

downstream data rate	up to 8 Mbps
upstream data rate	up to 1 Mbps
G.lite downstream data rate	up to 1.5 Mbps
G.lite upstream data rate	up to 512 Kbps
G.dmt.bis downstream data rate	up to 12 Mbps
G.dmt.bis upstream data rate	up to 12 Mbps

ADSL2 Standards

full rate downstream data rate	up to 24 Mbps
full rate upstream data rate	up to 1 Mbps

Wireless LAN

wireless speed	up to 300 Mbps
frequency range	2.4 GHz to 2.484 GHz
antennas	2 non-detachable dipole