Section 3 - Configuration
D-Link DSL-2740B User Manual
55
WIRELESS QOS RULES CONFIGURATION
WMM is used to prioritize the data packets from LAN to WLAN. It is very
useful when transmitting delay-sensitive packets like VoIP.
Select Disabled of WMM No Acknowledgment to avoid re-transmission of
highly delay-sensitive packets
Click Add QoS Entry to configure your own rule.
Note: WMM only operates In 11b/g mode.
Enter the Name and Priority (1~8, 8 is the highest) of the rule.
Specify traffic classification rules. The classification can be defined in the
following parameters: Protocol, Source/Destination IP Range, and
Source/Destination Port Range. If multiple conditions are entered, all
conditions must be matched to take effect.
Click on the Apply button to apply this rule.
Activate Wireless QoS Rules
Click on the Apply WME Settings button to activate the WMM QoS rule.
Check the specified rule and click on the Remove button to delete.
To Next Page
Loading...
Need help?
ADSL Standards
