DSL-G2452GR AC1200 MU-MIMO Wireless Dual Band
VDSL2 Router with ADSL2+/3G/LTE/Gigabit Ethernet WAN
Support, 2 FXS Ports and USB Port
User Manual
Configuring via Web-based Interface
In order to enable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the right. Then specify the needed parameters.
Parameter Description
Configuration
Hostname
A name of the router for identification in the SNMP manager.
The contact information
for the administrator
Additional information used to contact the administrator of the
router.
System location
Additional information used to locate the router.
If needed, specify an IP address of the remote subnet for which access to the SNMP agent of the
router will be allowed. To do this, in the Remote subnets section, click the ADD button and
enter the address of the subnet in the line displayed.
To remove an IP address of the subnet, click the Delete icon ( ) in the relevant line.
If the SNMP manager operates over SNMPv2c, create a read-only community which will be used
by the SNMP manager to get data on the device. To do this, in the Communities section, click the
ADD button and specify the community name in the line displayed.
To remove a community, click the Delete icon ( ) in the relevant line.
If the SNMP manager operates over SNMPv3, create a read-only user which will be used by the
SNMP manager to get data on the device. To do this, in the Users section, click
the ADD button ( ).
Figure 181. The window for adding a user.
Page 238 of 358
To Next Page
Loading...
