DSL-G2452GR AC1200 MU-MIMO Wireless Dual Band
VDSL2 Router with ADSL2+/3G/LTE/Gigabit Ethernet WAN
Support, 2 FXS Ports and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Hotline
Enable hotline
Move the switch to the right to make the phone connected to this
line dial the number specified in the Number field after the receiver
is lifted.
Number
A number dialed by the phone connected to this line after the
receiver is lifted. Also you can specify a number in the format
phone_number@IP_address for direct IP calls bypassing the
SIP proxy server. The field is available for editing if the Enable
hotline switch is moved to the right.
Connect after
A time period (in seconds) between lifting up the receiver and
dialing the hotline number. The field is available for editing if the
Enable hotline switch is moved to the right.
Forwarding
Enable
In the corresponding sections, move the Enable switch to the right
to enable forwarding always, on busy, or if there is no answer. When
the switch is moved to the right, the Call forwarding number and
Number of calls fields are available for editing.
Move the corresponding switch to the left if forwarding is not
required.
Call forwarding number
A number to which the router redirects calls.
Number of calls
The number of calls before the router forwards a call to the number
specified in the Call forwarding number field. The field is
available for editing if the Enable switch in the If no answer
section is moved to the right.
After specifying the needed parameters, click the APPLY button.
To add a new line, in the List of SIP Lines section, click the ADD button ( ). On the opened
page, specify the needed parameters and click the APPLY button.
Page 277 of 358
To Next Page
Loading...
