D-Link DWL-8600AP

D-Link Unified Access Point CLI Reference Manual
14 © 2001- 2009 D-Link Corporation. All Rights Reserved
STATUS
Use the commands in this section to view various AP status information.
Set the password set system password <password>
Example:
set system password test1234
Set the baud rate for the serial port set serial baud-rate
Set the system name set system system-name <name>
Example:
set system system-name "AEO AP"
Set the system location set system system-location <location>
Set the administrator’s contact information set system system-contact <contact_info>
Note: Make sure you are familiar with the names of the interfaces as described in “Interface Naming Conventions”
on page 11. The interface name you reference in a get command determines whether the command output shows
a wired or wireless interface, the Internal network, or to radio “one” or radio two.”
Table 6: Status Commands
Action Command
Global command to get all detail on a Basic Service Set (BSS).
This is a useful command to use to get a comprehensive picture of how
the AP is currently configured.
get bss all detail
Get information about the wired and WLAN interfaces get interface
Get the MAC Address for the Wired Internal Interface get interface wlan0 mac
Get the VLAN ID for the wired interface get management vlan-id
Get the Network Name (SSID) for the default virtual access point. get interface wlan0 ssid
Get the Current IEEE 802.11 Radio Mode get radio wlan0 mode
Get the Channel the AP is Currently Using get radio wlan0 channel
Get Basic Radio Settings for the Internal Interface get radio wlan0
get radio wlan0 detail
Get Client Associations get association detail
Get neighboring access points get detected-ap detail
Get information about switches that can discover and manage the AP get managed-ap
Table 5: Basic Setting Commands (Cont.)
Action Command
Review Copy