D-Link Unified Access Point CLI Reference Manual
18 © 2001- 2009 D-Link Corporation. All Rights Reserved
IEEE 802.1X SUPPLICANT AUTHENTICATION
Use the 802.1X Supplicant Authentication settings to configure the access point to authenticate to a secured wired network.
Configure the IP address of up to four D-
Link Wireless Switches on your network.
set managed-ap switch-address-1 <ip_address>
set managed-ap switch-address-2 <ip_address>
set managed-ap switch-address-3 <ip_address>
set managed-ap switch-address-4 <ip_address>
Example:
set managed-ap switch-address-1 192.168.2.123
Table 10: IEEE 802.1X Supplicant Commands
Action Command
Enable 802.1X supplicant set dot1x-supplicant status up
Disable 802.1X supplicant set dot1x-supplicant status down
Set the 802.1X user name set dot1x-supplicant user <name>
Set the 802.1X password set dot1x-supplicant password <password>
Table 9: Managed Access Point Commands
Action Command
Review Copy
To Next Page
Loading...
