D-Link DWR-116 - Outbound Filter

40D-Link DWR-116 User Manual
Section 3 - Conguration
Select this box to Enable the lter.
You may select Always On or choose the
number of a schedule rule that you have
dened.
Copies the predened lter to the specied ID
Identies the lter.
Specify the local IP address and then specify
the port after the colon.
Specify the remote IP address and then the
port after the colon.
Select this box to enable the lter.
Specify the schedule rule number.
Go back to the previous lter page.
Advance to the next lter page.
Click Save Settings to save your changes,
or click Don’t Save Settings to discard your
changes.
Outbound Filter
Outbound Filter:
Use Schedule
Rule:
Copy to ID:
ID:
Source IP : Ports:
Destination IP :
Ports:
Enable:
Schedule Rule #:
Previous Page:
Next Page:
Outbound Filter enables you to control what packets are
allowed to pass through the router. Outbound filter applies on
all outbound packets.