D-Link DWR-116 - Inbound Filter

41D-Link DWR-116 User Manual
Section 3 - Conguration
Select this box to Enable the lter.
You may select Always On or choose the
number of a schedule rule that you have
dened.
Copies the predened lter to the specied ID
Identies the lter.
Specify the local IP address
Specify the local port after the colon.
Specify the remote IP address
Specify the remote port after the colon.
Select this box to enable the lter.
Specify the schedule rule number.
Go back to the previous lter page.
Advance to the next lter page.
Click Save Settings to save your changes,
or click Don’t Save Settings to discard your
changes.
Inbound Filter
Inbound Filter:
Use Schedule
Rule:
Copy to ID:
ID:
Source IP :
Source Ports:
Destination IP :
Destination Ports:
Enable:
Schedule Rule #:
Previous Page:
Next Page:
Inbound Filter enables you to control what packets are allowed
to pass through the router. Inbound filter only applies to packets
that are destined for Virtual Servers or DMZ hosts.