3. Open a command prompt, and type ping 192.168.0.1, and then press Enter.
◼ If the result displayed is similar to Figure 4-7, it means the connection between your PC and t he
Router has been established well.
Figure 4-7 Successful Ping Command
◼ If the result
displayed is similar to Figure 4-8, it means the connection between your PC and t he Router has
failed.
Figure 4-8 Failed Ping Command
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some
firewall software programs may block a DHCP request on newly installed adapters.
To Next Page
Loading...
