D-Link GO-RT-N150 - Page 17

13D-Link GO-RT-N150 User Manual
Section 3 - Conguration
According to the detection result, the wizard will
indicate the type of Internet connection that you’re
currently use.
You can configure your wireless network. Click
Congure button in Wireless Settings. Select the
type of Wireless security you use (Disable Wireless
Security or AUTO-WPA/WPA2) and enter the
network name (SSID, Service Set Identier) and
security password. The network name(SSID) is the
name of your wireless network. Create a name using
up to 32 characters.
If the type is Dynamic IP(DHCP), click Save to
continue.
If the type is PPPoE, enter your PPPoE username
and password. Click Next to continue.
If the type is Static IP, please enter the IP
address, subnet mask, gateway, and DNS server
addresses that your ISP assigned to you. Click
Connect to continue.
Note: Make sure to remove your PPPoE software
from your computer. The software is no longer
needed and will not work through a router.