D-Link GO-RT-N150 - DHCP Server Settings

22D-Link GO-RT-N150 User Manual
Section 3 - Conguration
Check this box to enable the DHCP server on your
router. Uncheck to disable this function.
Enter the starting and ending IP addresses for the
DHCP server’s IP assignment.
Note: If you statically (manually) assign IP
addresses to your computers or devices, make
sure the IP addresses are outside of this range
or you may have an IP conict.
The length of time for the IP address lease. Enter
the Lease time in minutes.
Enable DHCP
Server:
DHCP IP Address
Range:
Lease Time:
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol. The GO-RT-N150 has a built-in DHCP server. The DHCP Server will
automatically assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be
DHCP clients by setting their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers
on, they will automatically load the proper TCP/IP settings provided by the GO-RT-N150. The DHCP Server will
automatically allocate an unused IP address from the IP address pool to the requesting computer. You must specify
the starting and ending address of the IP address pool.