D-Link GO-RT-N150 - Configure WPA-Personal (PSK)

48D-Link GO-RT-N150 User Manual
Section 4 - Security
Congure WPA-Personal (PSK)
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Setup and then click Wireless Settings on the left side and then
click Manual Wireless Network Setup.
2. Next to Security Mode, select WPA/WPA2.
3. Next to Cypher Type, select AUTO(TKIP/AES) TKIP, or AES. If you
have wireless clients that use both types, use AUTO(TKIP/AES).
4. Next to Pre-Shared Key, enter a key (passphrase). The key is entered as a pass-phrase in ASCII format at both ends
of the wireless connection. The pass-phrase must be between 8-63 characters.
5. Click Save Settings to save your settings. If you are conguring the router with a wireless adapter, you will lose
connectivity until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the router.