64D-Link DIR-X1860 User Manual
Section 3 - Configuration
DCHP Server
Status Enable or disable the DHCP server.
DHC IP Address Range Enter the starting and ending IP addresses for the D
HCP
server's IP assignment. Note: If you statically assign IP addresses
to your computers or devices, make sure the IP addresses are
outside of this range or you may have an IP conflict.
DHCP Lease Time Enter the length of time for the IP address lease in minutes.
Always Broadcast Enable this feature to broadcast your network's DHCP server
to LAN/WLAN clients.
Advanced Settings
UPnP Enable or disable Universal Plug and Play (UPnP). UPnP
provides compatibility with networking equipment, software,
and peripherals.
Enable to allow IPv4 multicast traffic to pass through the router
from the Internet. This is enabled by default.
Enable to allow IPv6 multicast traffic to pass through the router
from the Internet. This is enabled by default.
To Next Page
Loading...
Need help?
General
