63D-Link DIR-X1860 User Manual
Section 3 - Configuration
Network
In the Settings menu on the bar at the top of the page, click Network to change the local network settings of the router and
to configure the DHCP settings.
Click Save at any time to save the changes you have made on this page.
Network Settings
LAN IP Address Enter the IP address of the router. The default IP address is
192.168.0.1. If you change the IP address, once you click Save,
you will need to enter the new IP address in your browser to
get back into the configuration utility.
Subnet Mask Enter the subnet mask of the router. The default subnet mask
is 255.255.255.0.
Management Link The default address to access the router’s configuration is
http://dlinkrouter.local/. You can replace dlinkrouter with
a name of your choice.
Local Domain Name Enter the domain name (optional).
Enable DNS Relay Disable to transfer the DNS server information from your ISP
t
o your computers. If enabled, your computers will use the
router for a DNS server.
Enable Link
Aggregation
Link aggregation combines port 1 and port 2 of the Gigabit
Ethernet LAN ports to boost throughput. Enable this feature
for devices that support link aggregation and connect the
device to port 1 and 2 of the DIR-X1860.
To Next Page
Loading...
