50D-Link M15 User Manual
Section 3 - Conguration
DHCP Server
Status Enable or disable the DHCP server.
DHCP IP
Address Range
Enter the start and end IP addresses for the DHCP server's IP
assignment.
Note: If you have reserved static IP addresses to client devices, make
sure the IP addresses are outside of this range or you might have an IP
conict. Refer to Connected Clients on page 13 for how to reserve
IP addresses for clients.
DHCP Lease
Time
Enter the length of time for IP address lease in minutes. The default
is 10080 minutes.
Always
Broadcast
Enable this feature to broadcast your network's DHCP server to LAN/
WLAN clients.
Advanced Settings
WAN Port
Speed
You may set the port speed of the Internet port to 10 Mbps, 100
Mbps, 1000 Mbps, or Auto (recommended).
UPnP Enable or disable Universal Plug and Play (UPnP). PnP provides
compatibility with networking equipment, software, and peripherals.
This is enabled by default.
IPv4 Multicast
Streams
Allow or disallow IPv4 multicast trac to pass through the device
from the Internet. This is enabled by default.
IPv6 Multicast
Streams
Allow or disallow IPv6 multicast trac to pass through the device
from the Internet. This is enabled by default.
Click Save when you are done.
Network (Continued)
To Next Page
Loading...
Need help?
General
