Why does my Da-Lite Projection Screen keep coasting?
If your Da-Lite Projection Screen is coasting, it's likely due to a defective brake. The suggested solution is to replace the motor assembly.
Why is my Da-Lite Projection Screen so noisy?
If your Da-Lite Projection Screen is making excessive noise (beyond a low-pitched hum), it could be gear noise. The suggested solution is to replace the motor assembly.
What to do if my Da-Lite Projection Screen will not operate?
If your Da-Lite Projection Screen isn't working, here are a few things to check: * **Blown fuse:** Replace the fuse. * **Tripped circuit breaker:** Reset the circuit breaker. * **No power:** Check the operating switch or junction. * **Thermal overload:** Let the motor cool down for 15 minutes, then try again. * **Broken wire:** Tighten any loose wire connections. * **Defective motor, limit switch, or capacitor/Capacitor burned out:** Replace the motor assembly.
Why is my Da-Lite Projection Screen making noise?
If your Da-Lite Projection Screen is making noise, it could be gear noise. The suggested solution is to replace the motor assembly.
What to do if my Da-Lite Tensioned Large Cosmopolitan Electrol is coasting?
If your Da-Lite Projection Screen is coasting, it's likely due to a defective brake. You should replace the motor assembly.
What to do if my Da-Lite Tensioned Large Cosmopolitan Electrol won't operate and the motor doesn't hum?
If your Da-Lite Projection Screen isn't working and the motor is silent, here's what you can check: * **Blown fuse:** Replace the fuse. * **Tripped circuit breaker:** Reset the circuit breaker. * **Power issues:** Ensure there's power to the switch or junction. Check and tighten any loose wire connections, and correct any improper connections. Test for power across the black and white leads in the 'down' position, and across the red and white leads in the 'up' position. * **Thermal overload:** Let the motor cool down for 15 minutes before trying again. * **Broken wire:** Check for continuity in the 'down' or 'up' position. Cut off the old splice and reconnect. * **Defective components:** If none of the above steps work, the motor, limit switch, or capacitor might be defective....
Essential safety guidelines for using the projection screen and associated equipment.
Wiring configuration for controlling the screen with a standard wall switch.
Instructions for connecting control panels to the 240V low voltage system.
Solutions for screens not operating or motor-related issues.
General| Motorized | Yes |
|---|---|
| Remote Control | Yes |
| Sizes | Custom sizes available |
| Installation Type | Ceiling or wall mount |
| Voltage | 120V |
| Case | aluminum |
| Mounting | Ceiling or wall mount |
| Size Options | Custom sizes available |
| Aspect Ratio | 16:9 |
To Next Page