Why is my Da-Lite Projection Screen fabric hanging crooked?
If the fabric on your Da-Lite Projection Screen hangs crooked, it might be due to: * Improper installation: Check if the screen is level and plumb. * Fabric damage: Consider replacing the fabric if it's damaged.
Why is my Da-Lite Large advantage electrol making noise?
If your Da-Lite Projection Screen is generating noise, note that a low-pitched hum during operation is normal. However, if you hear a buzzing noise, adjust the door limit switch, as it may be too far down. For gear noise, consider replacing the motor assembly.
What causes coasting in Da-Lite Large advantage electrol?
Coasting in a Da-Lite Projection Screen is typically caused by a defective brake. The suggested solution is to replace the motor assembly.
What to do if roller displaced from mounting bracket in Da-Lite Large advantage electrol?
If the roller is displaced from the mounting bracket in your Da-Lite Projection Screen, it's likely that the pin end slipped out of the nylon bearing. Realign the pin end bracket to resolve this.
What to do if Da-Lite Interactive whiteboard screen will not operate and motor does not hum?
First, verify that the voltage is within the correct range (115-125V or 220-240V). If the voltage is insufficient, rewire the incoming electric line. Then, replace the fuse if it's blown, or reset the circuit breaker if it's tripped. Check all wiring for loose or improper connections and correct them. Finally, check for power across the black and white leads in the down position, and across the red and white leads in the up position.
Why is my Da-Lite Interactive whiteboard fabric hanging crooked?
A crooked fabric hang typically occurs due to improper screen installation, the fabric backing up inside the case, or fabric damage. Ensure the screen is level and plumb. If the fabric has backed up, carefully adjust the 'down' limit switch until the roller is exposed and the wrinkle disappears, then readjust for the proper drop. If the fabric is damaged, consider replacing it.
What to do if Da-Lite Interactive whiteboard screen will not operate but there is power at junction box?
If your screen isn't operating despite power at the junction box, the thermal overload may have tripped. Let the motor cool down for 15 minutes before trying again. Also, check for continuity in the wiring, especially for breaks in the 'down' or 'up' positions; if found, cut off the old splice and reconnect. A defective motor, limit switch, or capacitor could also be the cause. Since the motor is a sealed assembly, you would need to replace the entire motor assembly.
Why is my Da-Lite Interactive whiteboard coasting?
Coasting is caused by a defective brake. To resolve this, replace the motor assembly.
How to fix noise from Da-Lite Interactive whiteboard?
Noise from your screen can be caused by several factors: squeaking from the rubber end plug rubbing on the motor, grinding noises, a foreign object rubbing on the roller or fabric, or gear noise. Try centering the roller in the case. If the noise persists, remove the foreign object. Otherwise, replace the motor assembly.
What to do if Da-Lite Projection Screen won't operate and motor doesn't hum?
If your Da-Lite Projection Screen isn't working and the motor is silent, it could be due to several reasons: * Incorrect line voltage: Ensure it's between 115-125V (or 220-240V). Rewire if needed. * Blown fuse: Replace the fuse. * Tripped circuit breaker: Reset it. * Power issues: Check the operating switch or junction. Tighten any loose wire connections and correct improper connections. Verify power across the black and white leads in the down position, and across the red and white leads in the up position.
Adjusts the screen to extend further down using the 'down' limit knob.
Adjusts the screen to retract more using the 'down' limit switch.
General| Brand | Da-Lite |
|---|---|
| Model | Large advantage electrol |
| Category | Projection Screen |
| Language | English |
To Next Page