How to fix a Da-Lite Large advantage electrol when the fabric hangs crooked?
If the fabric on your Da-Lite Projection Screen hangs crooked, consider these solutions: * Check the installation: Ensure the screen is level and plumb. * Adjust the down limit switch: Slowly adjust the "down" limit switch until the roller is exposed and the wrinkle comes out, then readjust for proper drop. * Fabric damage: If the fabric is damaged, replace it.
What to do if Da-Lite Projection Screen won't operate but there is power at the junction box?
If your Da-Lite Projection Screen isn't working despite power at the junction box, the following might be the cause: * Thermal overload: Let the motor cool down for 15 minutes and try again. * Broken wire: Check for continuity and reconnect any broken wires. * Defective components: The motor, limit switch, or capacitor might be defective. Replace the motor assembly. Note that the motor is a sealed assembly.
How to reduce noise from a Da-Lite Large advantage electrol Projection Screen?
If your Da-Lite Projection Screen is making noise, here are some possible causes and solutions: * Squeaking: If the rubber end plug is rubbing on the motor, center the roller in the case. * Grinding: If a foreign object is rubbing on the roller or fabric, remove it. * Gear noise: Replace the motor assembly.
Why Da-Lite Projection Screen is coasting?
If your Da-Lite Projection Screen is coasting, it's likely due to a defective brake. Replace the motor assembly.
What to do if Da-Lite Projection Screen will not operate?
If your Da-Lite Projection Screen isn't working, and the motor isn't humming, there could be several reasons: * Incorrect line voltage: Verify it's between 115-125V (or 220-240V). If it's not sufficient, rewire the incoming electric line. * Blown facility fuse: Replace the fuse. * Tripped facility circuit breaker: Reset the breaker. * No power to the operating switch or junction box: Check the power and tighten any loose wire connections. Recheck the wiring, consulting the installation instructions. * Low voltage board has no power, or the transformer is blown: Replace the low voltage board and check for power across the black and white leads in the “down” position. If the motor hums, it could be: * Thermal overload tripped: Let the motor cool down for 15 minutes, then try a...
What to do if Da-Lite Projection Screen will not move upward?
If your Da-Lite Projection Screen isn't moving upward, consider these potential causes: * Incorrect line voltage: Make sure the voltage is within 115-125V (or 220-240V). If not, rewire the incoming electric line. * Blown facility fuse: Replace the facility fuse. * Tripped facility circuit breaker: Reset the circuit breaker. * No power to the operating switch or junction box: Check the power supply and tighten any loose wire connections. * Low voltage board has no power, or the transformer is blown: Replace the low voltage board and check for power across the red and white leads in the “up” position. * Thermal overload tripped: Allow the motor to cool down for 15 minutes before trying again. * Broken wire in the “up” position: Check for continuity. * Defective motor, limit ...
Adjusts the screen to extend further down using the 'down' limit knob.
Adjusts the screen to retract more using the 'down' limit switch.
General| Brand | Da-Lite |
|---|---|
| Model | Large advantage electrol |
| Category | Projection Screen |
| Language | English |
To Next Page