Why is my Da-Lite Projector Accessories making noise?
If your Da-Lite Projector Accessories is making noise, and it's a buzzing sound, try adjusting the door limit switch, as it might be too far down. If the noise is related to the gears, you may need to replace the motor assembly.
What to do if the door on my Da-Lite Tensioned Advantage Deluxe Electrol will not open?
If the door on your Da-Lite Projection Screen won't open, it could be due to a hinge that is bound or obstructed by a foreign substance, preventing it from opening by gravity. Inspect the installation to ensure the door can move freely and clear any obstructions like paint or plaster from the hinge. Another potential cause is lack of power, so check the power supply.
Why is my Da-Lite Projection Screen making noise?
If your Da-Lite Projection Screen is making noise, note that a low-pitched hum during operation is normal. However, if you're hearing a buzzing noise, try adjusting the door limit switch, as it might be too far down. Gear noise, on the other hand, could indicate the need to replace the motor assembly.
Why does the fabric on my Da-Lite Tensioned Advantage Deluxe Electrol Projection Screen hang crooked?
If your Da-Lite Projection Screen fabric hangs crooked, it might be due to improper installation. Ensure that the screen is level and plumb. Alternatively, the fabric itself may be damaged, requiring replacement.
What to do if Da-Lite Projector Accessories door opens but screen does not operate?
If the door of your Da-Lite Projector Accessories opens but the screen doesn't operate, the issue might be a loose wire. Check all wiring and connections to ensure they are secure.
What causes a Da-Lite Tensioned Advantage Deluxe Electrol roller to be displaced?
If the roller is displaced from the mounting bracket on your Da-Lite Projection Screen, it's likely that the pin end slipped out of the nylon bearing. Realign the pin end bracket to resolve this issue.
What causes a Da-Lite Projection Screen door to close too early?
If the door on your Da-Lite Projection Screen closes before the screen is fully up, the screen 'up' limit is likely out of adjustment. Adjust the 'up' limit.
What to do if my Da-Lite Projection Screen door does not close?
If the door of your Da-Lite Projection Screen isn't closing, it could be due to an open door limit switch or a lack of power from the screen motor. Try replacing the switch or the screen motor.
How to fix a Da-Lite Tensioned Advantage Deluxe Electrol Projection Screen roller displaced from the mounting bracket?
If the roller is displaced from the mounting bracket on your Da-Lite Projection Screen, it may be due to the pin end slipping out of the nylon bearing. Try to realign the pin end bracket.
Why does the door close before the screen is all the way up on my Da-Lite Tensioned Advantage Deluxe Electrol?
If the door closes before the screen is fully up on your Da-Lite Projection Screen, the screen 'up' limit might be out of adjustment. Adjust the 'up' limit (call factory for instructions).
General| Installation Type | Ceiling or Wall Mount |
|---|---|
| Motorized | Yes |
| Aspect Ratio | 16:9 |
| Screen Size | Various sizes available |
| Case | Aluminum, Black or White finish |
| Tensioning System | Yes |
| Gain | 1.0 |
| Viewing Angle | 160 degrees |
To Next Page