The engine is started pressing this button
when pressed in a state where the main
switch key is placed to an ON position
and the brake lever is pulled.
<TURNING ON HEADLIGHT>
Put main switch key in “ON” position and
turn on headlight switch.
<DIMMER SWITCH>
High beam or low beam can be operated
by the use of dimmer switch.
HIGH BEAM
...... used when needing extra
light.
LOW BEAM
...... used when other vehicles
are present, in the city, etc.
12
HEADLIGHT
●The engine will not start if the brake
lever is not pulled.
●Do not hold the brake lever and
pull the throttle grip when the
engine was started. It may damage
the engine.
●Use the high beam only in the
suburban road or when the usage of
the high beam not hinder the safe
driving of the car ahead.
START BUTTON
DIMMER SWITCH
START BUTTON
SWITCH POSITION FUNCTION
Headlight, taillight,
position lamp and
meter lights on.
Position lamp, taillight,
and meter lights on.
Light turned off.
(OFF)
(P)
(H)
(LO)
D
(HI)
D
HEADLIGHT SWITCH
To Next Page
Loading...
Need help?
General
