1. General
1.1. General Repair Instructions
1) Equipment shall be safely parked on the ground, and propped front and rear wheel when work.
2) Prior to maintain, disconnect the grounding cable from the battery to be prevented the
damaged cable and burning due to short-circuiting.
3) Shield body and sheet with the coverlet in order to prevent of damage and getting stained.
4) All the persons handling brake oil and anti-freezing solution shall be carefully treated to be
undamaged the painting parts.
5) When maintain the specially designated parts, the appropriated tools or special tools shall be of
importance used to maintain the life span.
6) Changeable parts shall be rightly used the genuine parts of DAEWOO.
7) When the used cotter pins, gaskets, O-rings, oil seals, lock washer and self-lock nuts do reuse,
you may need to maintain again, so that why you use the brand new products.
8) Orderly place the disassembled parts in groups to be smoothly reassembled after maintained.
9) Prior to inspect reassemble, you must clean the parts, and also clean the perforated oil ring
with the compressed pneumatic in order to prevent of inflow an alien substance.
10) Prior to assemble, lubricate the oil or grease to the rotating and sliding faces of parts.
11) Adhere to the gaskets to prevent of leakage if necessary.
12) Getting tightened the bolts and nuts torque shall be comply with a rule.
13) Finally check to make sure when the maintenance has been done.
14) The system of an aerial parts for a safety shall be removed the compressed pneumatic without
fail when disassemble in a working.
- 1 -
To Next Page
Loading...
