Press key to enter missed call lists, received call lists or dialed call lists respectively.
1) The LCD will show the last record. (If no entries are available in the list, LCD will show
EMPTY
).
2) Press ∧ or ∨ key to view other record.
When the record is show,
press key, use ∧
or ∨
key to choose among
ADD TO PB? DELETE?
DELETE ALL?
Then press key to confirm
:
1)
ADD TO PB
(this function allows the user to add an entry from the caller list to the phone book, the
method please refer to “
To store an incoming or outgoing number in your phonebook
”)
2)
DELETE
(the function allows the user to delete the currently selected entry from caller list by pressing
R/C
key.)
3)
DELETE ALL
(
this
function allows the user to delete all numbers)
Note:
In idle state, press ∧ key once to incoming records or press ∨ key
to review outgoing records.
Handset Menu Function 3: Base settings
The user is able to change the base setting in base settings item, press
key and use
∧
or ∨
key to
select this item. Then you can do below:
To delete handset:
This function allows the user to delete a handset registration from the base.
1) Press key the first show is
DELETE HS
.
2) Press key to enter; the user will be prompted to enter the
PIN code (default as 0000).
3) Input the correct 4-digit pin code and press key to confirm
4) Press ∧ or ∨ key will scroll the handset names. Press
key to confirm.
The delete handset will be deleted from the list on registered handset on the base.
﹡
After you delete the handset, you will not be able to enter base settings menu in idle mode.
To set dial mode (Tone/Pulse)
The user can select to change the mode in which the base will dial.
1) Press key, then use ∧ or ∨ key to select
DIAL MODE
item.
2) Press
key to enter. Press ∧ or ∨ key to select the
TONE
or
PULSE
dialing mode.
3) Press key to confirm your selection.
Note:
According to your telephone lines or PABX systems you may need to change the dialing mode
between Tone and Pulse.
To set flash time
The user can select the flash time (100ms, 300ms, 600ms and 1000ms) to meet your telephone line or
PABX requirement.
1) Press key, then use ∧ or ∨ key to select
FLASH TIME
2) Press key to enter. Press ∧ or ∨ key to select the 100ms, 300ms, 600ms and 1000ms.
3) Press key to confirm your selection.
To change the PIN code
Some functions (including handset delete and base default) require a PIN code. The default PIN is 0000,
but you are able to change to your personal 4-digit PIN.
1) Press key, then use ∧ or ∨ key to select
MODIFY PIN
item.
To Next Page
Loading...