To Next PageTo Next PageHow to troubleshoot a Daewoo DWD-F1021 that won't start?
If your Daewoo Washer isn't operating, check for the following: * Is there a power failure? * Is the power cord correctly connected to an electrical outlet? * Have you turned on the power? * Did you press the Start/Hold button? * Is there the correct amount of laundry in the washer?
How to fix a Daewoo Washer with water supply error?
If water isn't being supplied to your Daewoo Washer, verify that the inlet hose is connected and the water tap is open. Check if the inlet hose or water tap are frozen, or if the water supply is shut off. Also, inspect the inlet hose filter for any foreign matter blocking it.
What to do if Daewoo Washer will not drain?
If your Daewoo Washer isn't draining, make sure the drain hose isn't frozen or blocked with dirt. Also, check if the drain hose is kinked or deformed, or if the end of the drain hose is immersed in water. Finally, inspect the drain filter for excessive dirt.
What does UE error mean on my Daewoo DWD-F1021?
To solve the UE UNBALANCE ERROR on your Daewoo washer, rearrange the laundry, because the laundry is concentrated to one side of the drum during spin.
What does E8 error mean on my Daewoo DWD-F1021 Washer?
To address the E8 MOTOR ERROR on your Daewoo washer, check the connector of the motor. If the motor does not work, you may need to replace it.
What does PFE error mean on my Daewoo Washer?
To fix the PFE PUMP FILTER ERROR on your Daewoo washer, clean the drain pump filter. If the drain pump does not work during spin, it may need to be replaced. Also, use the proper amount of detergent and place the drain hose 1m below the floor.
What to do if my Daewoo DWD-F1021 Washer shows a drain error?
If your Daewoo Washer is displaying a drain error, it could be due to several reasons. First, check the drain hose for any kinks or clogs and clean or straighten it. Other potential causes include a defective drain motor, valve inlet, or water level sensor, all of which would require replacement. It's also possible that the PCB ASS’Y is not checking the water level, which would also require replacement.
What to do if the Daewoo DWD-F1021 Washer door does not open?
If your Daewoo Washer door won't open, wait two minutes to allow the electric locking mechanism to release after the cycle has stopped. The door is designed to remain locked for safety reasons once a cycle has started.
Why does my Daewoo DWD-F1021 Washer not start?
If your Daewoo Washer isn't starting, ensure the power cord is securely plugged into the wall outlet. Also, check your house fuse or circuit breaker; reset the breaker or replace the fuse if necessary, without increasing its capacity. If a circuit overload is the issue, consult a qualified electrician. Finally, make sure the water supply tap is turned on.
How to fix a Daewoo Washer that won't drain?
If your Daewoo washer isn't draining water, or is draining slowly, inspect the drain hose for kinks or clogs and clean and straighten it. Also, check the drain filter for clogs and clean it.
General| Model | DWD-F1021 |
|---|---|
| Brand | Daewoo |
| Tub Material | Stainless Steel |
| Control Type | Electronic |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Type | Front Load |
| Dimensions (H x W x D) | 850 x 600 x 550 mm |
| Dimensions (W x D x H) | 600 x 550 x 850 mm |
