To Next PageTo Next PageWhat to do if the Daewoo DWD-F1021 Washer door does not open?
If your Daewoo Washer door won't open, wait two minutes to allow the electric locking mechanism to release after the cycle has stopped. The door is designed to remain locked for safety reasons once a cycle has started.
What to do if my Daewoo DWD-F1021 Washer shows a drain error?
If your Daewoo Washer is displaying a drain error, it could be due to several reasons. First, check the drain hose for any kinks or clogs and clean or straighten it. Other potential causes include a defective drain motor, valve inlet, or water level sensor, all of which would require replacement. It's also possible that the PCB ASS’Y is not checking the water level, which would also require replacement.
How to fix an unbalance error on a Daewoo Washer?
An unbalance error on your Daewoo Washer typically occurs when the laundry is concentrated on one side of the drum during the spin cycle. To resolve this, rearrange the laundry to distribute the weight more evenly.
What to do if my Daewoo DWD-F1021 won't start?
If your Daewoo washer isn't starting, ensure the power cord is securely plugged into the wall outlet. Check your house fuse or circuit breaker, and reset it if necessary. Also, verify that the water supply tap is turned on.
How to fix a Daewoo Washer that won't spin?
If your Daewoo washer won't spin, make sure the door is firmly shut. Close the door and press the Start/Pause button. After pressing the Start/Pause button, it may take a few moments before the clothes washer begins to spin. The door must lock before spin can be achieved.
What to do if Daewoo Washer will not drain?
If your Daewoo Washer isn't draining, make sure the drain hose isn't frozen or blocked with dirt. Also, check if the drain hose is kinked or deformed, or if the end of the drain hose is immersed in water. Finally, inspect the drain filter for excessive dirt.
How to fix a Daewoo Washer with water supply error?
If water isn't being supplied to your Daewoo Washer, verify that the inlet hose is connected and the water tap is open. Check if the inlet hose or water tap are frozen, or if the water supply is shut off. Also, inspect the inlet hose filter for any foreign matter blocking it.
How to troubleshoot a Daewoo DWD-F1021 that won't start?
If your Daewoo Washer isn't operating, check for the following: * Is there a power failure? * Is the power cord correctly connected to an electrical outlet? * Have you turned on the power? * Did you press the Start/Hold button? * Is there the correct amount of laundry in the washer?
What to do if my Daewoo Washer does not start?
If your Daewoo Washer won't start, ensure the power cord is securely plugged into the wall outlet. A loose connection can prevent the washer from starting. Also, check your house fuse or circuit breaker. If a fuse is blown or the breaker is tripped, reset the breaker or replace the fuse. Finally, make sure that the water supply tap is turned on.
How to fix water not entering my Daewoo Washer?
If water isn't entering your Daewoo washer, or is entering slowly, start by checking if the water supply is adequate in your area by checking another tap in the house. Ensure the water supply tap is fully open and that the water inlet hose isn't kinked. Also, the filter of the water inlet may be clogged, so check it.
General| Model | DWD-F1021 |
|---|---|
| Brand | Daewoo |
| Tub Material | Stainless Steel |
| Control Type | Electronic |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Type | Front Load |
| Dimensions (H x W x D) | 850 x 600 x 550 mm |
| Dimensions (W x D x H) | 600 x 550 x 850 mm |
