To Next PageTo Next PageWhat to do if my Daewoo DWD-F1021 Washer leaks water?
If your Daewoo Washer is leaking water, check and tighten the inlet and drain hose connections at both the tap and the washer itself. Additionally, inspect your house drain pipes for clogs and unclog them. If the problem persists, it may be necessary to contact a plumber.
How to fix Daewoo Washer that does not drain?
If your Daewoo Washer is not draining water properly or is draining slowly, begin by checking the drain hose for any kinks or clogs; clean and straighten the hose if needed. Also, inspect the drain filter for any blockages and clean it thoroughly.
How to fix Daewoo DWD-F1021 Washer that will not spin?
If your Daewoo Washer is not spinning, make sure that the door is firmly shut. Close the door properly and press the Start/Pause button. Note that it may take a few moments after pressing the button for the washer to begin spinning, as the door must lock first.
How to fix E4 LEAKAGE ERROR on Daewoo DWD-F1021 Washer?
To resolve the E4 LEAKAGE ERROR on your Daewoo Washer, check for leaks in the tub or the hose drain. Then change the tub or the hose drain.
How to fix E9 SENSOR PRESSURE ERROR on Daewoo DWD-F1021 Washer?
To resolve the E9 SENSOR PRESSURE ERROR on your Daewoo Washer, you should change the water level sensor.
How to fix H5 WATER TEMP. ERROR on Daewoo Washer?
To resolve the H5 WATER TEMP. ERROR on your Daewoo Washer, you should change the thermistor wash.
How to fix PFE PUMP FILTER ERROR on Daewoo Washer?
To resolve the PFE PUMP FILTER ERROR on your Daewoo Washer, clean the drain pump filter. If problems persist you should change the drain pump. Also use the proper amount of detergent and place the drain hose 1m below the floor.
Why does my Daewoo DWD-F1021 show a water inlet error?
A water inlet error on your Daewoo Washer can occur for several reasons: * The water tap might be closed; in this case, open the water tap. * The filter of the valve inlet could be clogged; clean the filter. * The valve inlet or the water level sensor might be defective, requiring replacement. * The drain motor may be running during water supply, also requiring replacement. * The PCB ASS’Y might not be checking the water level, also requiring replacement.
What to do if my Daewoo DWD-F1021 shows a door open error?
If your Daewoo Washer displays a door open error, make sure the door is fully closed. If the Start/Hold button was pressed while the door was open, simply close the door. If the error persists, the switch door lock may be defective and need to be replaced. It's also possible that the PCB ASS’Y is not checking the door lock, and would also require replacement.
How to fix a Daewoo DWD-F1021 when the water drains slowly?
If the water in your Daewoo washer isn't draining properly or drains slowly, check the drain hose for kinks or clogs and clean and straighten it. Also, inspect the drain filter for clogs and clean it.
General| Model | DWD-F1021 |
|---|---|
| Brand | Daewoo |
| Tub Material | Stainless Steel |
| Control Type | Electronic |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Type | Front Load |
| Dimensions (H x W x D) | 850 x 600 x 550 mm |
| Dimensions (W x D x H) | 600 x 550 x 850 mm |
