To Next PageTo Next PageWhat to do if the door of my Daewoo Washer does not open?
If your Daewoo Washer door won't open, once started, the door cannot be opened for safety reasons. Wait two minutes before attempting to open the door to allow the electrical locking mechanism time to release.
Why is my Daewoo DWD-G1081S not starting?
Your Daewoo Washer might not start due to several reasons: * The power cord may not be properly plugged in. Ensure the plug fits tightly in the wall outlet. * A house fuse may be blown, the circuit breaker tripped, or there is a power outage. Reset the circuit breaker, but do not increase the fuse capacity. If a circuit overload is the problem, have it corrected by a qualified electrician. * The water supply tap might not be turned on. Make sure to turn on the water supply tap.
How to fix a Daewoo DWD-G1081S that won't drain?
If your Daewoo Washer isn't draining, it could be due to: * A kinked or clogged drain hose. Clean and straighten the drain hose. * A clogged drain filter. Clean the drain filter.
What to do if Daewoo Washer door does not open?
Wait two minutes before opening the door to allow the electric locking mechanism time to release.
What to do if my Daewoo Washer is leaking water?
If your Daewoo Washer is leaking water, check the following: * Inlet or drain hoses might be loose at the tap or washer. Check and tighten the hose connections. * House drain pipes could be clogged. Unclog the drain pipe, and contact a plumber if necessary.
Why is my Daewoo Washer not spinning?
If your Daewoo Washer won't spin, ensure that the door is firmly shut. Close the door and press the Start/Hold button. After pressing the Start/Hold button, it may take a few moments before the cloth begins to spin.
What to do if water enters Daewoo DWD-G1081S slowly?
If water is entering your Daewoo Washer slowly, consider the following: * The water supply in your area may not be adequate. Check another tap in the inlet house. * The water supply tap may not be completely open. Fully open the tap. * The water inlet hose may be kinked. Straighten the hose. * The filter of the water inlet may be clogged. Check the filter of the water inlet.
Why is my Daewoo DWD-G1081S leaking water?
If your Daewoo Washer is leaking water, check and tighten the inlet and drain hose connections at both the tap and the washer. Also, inspect your house drain pipes for clogs and unclog them. If necessary, contact a plumber.
What causes the 'IE WATER IN ERROR' on a Daewoo DWD-G1081S?
If you see the 'IE WATER IN ERROR' message on your Daewoo Washer, first, ensure that the water tap is fully open. If it is, check the filter of the valve inlet for any clogs and clean it. If the issue persists, the valve inlet, water level sensor, or drain motor may be faulty and need to be replaced. It's also possible the PCB ASS’Y isn't checking the water level correctly, requiring replacement.
Why is my Daewoo DWD-G1081S Washer making a vibrating noise?
If your Daewoo Washer is making a vibrating noise, first check if all the transit bolts and packing have been removed from the back of the washer. If not, refer to the installation guide to remove them. Also, ensure all the feet are resting firmly on the ground. If the noise persists, the wash load may be unevenly distributed; stop the washer and rearrange the load.
General
