17
GUIDE FOR OTHER USEFUL PROGRAMS
1. Steam Spray (To reduce wrinkles)
Press ‘Start/Pause’ Button
• The ‘Steam Spray’ program is not like other washing or drying cycles.
• Due to the characteristics of cotton fibers, this program is not recommended for 100% cotton clothing.
• Remove stains from clothing before using the ‘Steam Spray’ program to prevent permanently setting the stains
by high heat.
• Be sure the faucet is open. This program uses little water to produce steam.
• Be careful not to touch the door. It can be very hot.
• Do not load the following items:
- Wool, blankets, leather jackets, silk, wet clothes, lingerie, foam products, or electric blankets.
• After removing clothes from the ‘Steam Spray’ program they may feel slightly damp. Wait at least 10 minutes
before putting the clothes on.
• Best results are achieved when articles are of similar size and fabric type. Do not overload.
• Do not reach into the washer while operating. Steam can cause severe burns.
• Keep pets away from the washer.
• REMEMBER be careful not to touch the door it can be VERY HOT.
1
Put 5 items or less into the Drum.
Then close the Door.
2
Press the Power button.
3
Select ‘Steam’ program using the program selection dial.
4
Press ‘Start/Pause’ Button.
To Next Page
Loading...
