22
HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
Clean the filter when water leaks from the water inlet.
① Pull the power plug out
before cleaning it.
② Turn off the water
supply to the washer
and separate the inlet
hose.
③ Pull the inlet filter out. ④ Remove the dirt from
the inlet filter with a
brush.
• If you want to clean the automatic detergent tanks. Please call Daewoo Customer Service for instructions on
how to clean the detergent tanks.
• You can access our internet site for instructions on cleaning the detergent tanks.
① Open the lower cover(1) by using
a coin. Gently pull out the drain
hose.
② Unplug the cap hose(2), allowing
the water to flow out entirely.
At this time use a vessel to
prevent water flowing on to the
floor. When water does not flow
any more replace the hose cap.
Then, turn the pump filter(3)
counter clockwise to open.
③ Remove any foreign material
from the pump filter(3).
After cleaning, turn the pump
filter clockwise.
Close the lower cover.
Cleaning the drain filter
• This drain filter is used to screen foreign objects such as threads, coins, pins, buttons etc.
• The drain filter should be cleaned after every 10 loads of wash, otherwise drain problems might occur.
CAUTION : Use caution when draining since the water might be HOT.
To Next Page
Loading...
Need help?
General
