20
Note : The water temperature selection is possible.
6. RINSE+SPIN (Select this option to Rinse and Spin a load separately from a regular cycle)
1
Put the laundry into the Drum and check the detergent and softener level in the
dispensers.
Then close the Door.
Note : For proper use of detergent dispenser please refer to "OPERATING YOUR
WASHER" (refer to page 10)
2
Press the Power button.
• The LED shows only ‘- --’ signal.
Note : If one or all of the detergent dispensers are low, the low detergent indicator will
light and the beeper will sound. The washer will still operate.
3
Select the program you want by using the program selection dial.
• If you press ‘RINSE+SPIN’ button without selecting a program, the ‘Normal’ program is
selected as default program.
4
Press the ‘RINSE+SPIN’ button.
•
‘1’ time rinse and ‘Medium’ rpm spin speed and ‘Cold/Cold’ water temperature are
selected automatically.
• ‘Low’ rpm spin speed is selected in ‘DELICATE’ program.
• If you want to change the Rinse time(s)and Spin condition, press each corresponding
button.
5
Press the ‘Start/Pause’ button.
• The door will lock and the washer will begin to operate.
5. SPIN ONLY
1
Put the laundry into the Drum and close the Door.
2
Press the Power button.
• The LED shows only ‘- --’ signal.
Note : If one or all of the detergent dispensers are low, the low detergent indicator will
light and the beeper will sound. The washer will still operate.
3
Select the ‘SPEED’ you want by pressing ‘SPIN’ button repeatedly, you can select low,
medium, high or extra high.
• The ‘Normal’ program is selected automatically.
• The water temperature is selected to ‘Cold/Cold’ automatically.
4
Press the ‘Start/Pause’ button.
• The door will lock and the spin cycle will begin to operate.
To Next Page
Loading...
Need help?
General
