7
PROCEDURE
§§
è
Reserved Washing
§§
è
Partial Selection Among Wash, Rinse or Spin
step 1. Press power switch.
step 2. Press program button until the indicating lamps make the combinations you want.
If only spin lamp is turned on, that means you will operate your washer for spin only.
If rinse and spin lamp are turned on, that means you will operate your washer for rinse and spin.
If add lamp is turned on with other porcess lamps, that means the time of the corresponding porcess will
increase by 1~2 minutes, that is, if add is on with wash, rinse and spin, the time of each precess will increase
by 1~2 minutes. (Wash: add 2 min., Rinse: add 1 min., Spin: add 1 min.)
step 3. Press water level selector as your decision.
step 4. Press Start/Hold to start.
11
Processing
the Power
Switch
22
Selecting
Water level
§
HIGH
§
MID
§
LOW
§
ADD
§
WASH
§
RINSE
§
SPIN
Wash & Rinse
& Spin
Only Spin
Add & Wash
Add & RInse
& Spin
Add & Spin
Add & Wash
& Rinse & Spin
Only Wash
Rinse & Spin
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
§
ADD
§
WASH
§
RINSE
§
SPIN
44
Pressing
the Start/Hold
Switch
End of
Washing
It is Informed
by buzzer.
33
Selecting Course
1 Set your program as the above
procedure, remaining last step.
• Press the course selection button.
• Press the procedure selection but-
ton.
• But WOOL/SUIT course can not
reservation.
2 Press reservation button until the
digital monitor displays the finish-
ing time you want.
3 Press Start/Hold to start.
RES.
START
/ HOLD
To Next Page
Loading...
