8
5. DIRECTIONS FOR INSTALLATION AND USE
DIRECTIONS
The openings must not
be obstructed by carpet-
ing when the washing
machine is installed on a
carpeted floor.
§§
è
Installation Of The Under Base Cover [Option]
-DWF-5510/5511/5010/6011
§§
è
How To Install On An Inclined Place
¡ The place where it would be
exposed to direct sunlight.
¡ The place nearby a heater or heat
appliance.
¡ The place where it would be sup-
posed to be frozen in winter.
¡ The kitchen with coal gas and a
damp place like a bathroom.
NOTES
10Cm
Install the washer on a horizon-
tal solid floor. If the washer is
installed on an unsuitable floor,
it could make considerable
noise and vibration.
Installing Place
Never install in these places
1 Before installing your
washer, remove the
pad from the bottom
of the cabinet. Then,
separate under cover
from rear side of cab-
inet by unscrewing
and insert it into the
base.
2 Push the under-base
cover into the end, which
decrease the noise made
by this washer.
2
Check the Horizon
Status
Check the position of tub above
the center of the washer.
1
Horizon
Setting
After controlling the height
by turning the adjustable
leg, let the washer put
down to the ground.
Keep the machine body more
than 25cm apart from the wall
surface. It will make easy clean-
ing the drain filter which is
equipped at the back side of it.
And if it comes into contract
vibration may occur.
To Next Page
Loading...
