HOW TO CLEAN THE FILTER
13
Cleaning the Lint Filter
Cleaning the drain filter
• In case "Pump-Model" drain hose, this filter's equipped at the back side of washer.
• This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc ...
• If the drain filter is not cleaned at proper time (every 10 times of use), Drain problem could
be caused.
! Pull the Fiter frame up-
ward.
@ Turn the lint filter inside
out, wash to the lint off
with water
# Return the filter as it was,
and insert the filter frame
into the slot
! Pull the power
plug out before
cleaning it.
@ Turn off the water
supply to the
washer and
sperate the inlet
hose.
# Pull the inlet filter
out.
$ Remove the dirt
from the inlet
filter with a brush.
! Put down the remained
water in the hose. And
put a container under the
filter to collect water.
@ Turn the cap counter
clockwise.
# Pull out the filter
assembly.
$ Clean the drain filter. % Put in the filter along the
guiding prominence of
the case. Please note the
left position of the filter
adjusting the groove to
the guide rib.
^ Turn the cap clockwise
tightly.
Cleaning the water inlet filter
• Clean the filter when water leaks from, the water inlet.
To Next Page
Loading...
