• Press this switch to turn the power on or off.
• It can be used to choose water temperature to be supplied.
• As the button is pressed, water temperature will be repeated.
COLD ➝ COLD+HOT ➝ HOT
• In case of the single valve model, there is no wash temperature
selector function.
• It can be used to adjust amount of water according to the size of the
load to be washed.
• As the button is pressed, water level is selected by
MEDIUM ➝ HIGH ➝ SMALL ➝ LOW
• It can be used to pre-engage time for wash.
• It is the button for the partial process or the combination of each
process (wash, rince, spin) (See page 10)
• If you want to change wash time, rince times, spin time, you must
press this button after selecting each process by the process button.
Also, this button can be used to spin only. (See page 10)
• It can be used to select the full-automatic course.
• As the button is pressed, course will be selected by following order:
FUZZY ➝ BLANKET ➝ ECONOMY ➝ SUIT ➝ SOAK
• Operation and temporary stop is repeated as it is pressed.
• When you want to change course in operating;
press the "START/HOLD" button ➝ Select the course that you want to
change ➝ press the "START/HOLD" button again.
To Next Page
Loading...
