1
EXTERNAL CAB COMPONENTS
Removal and installation 95XF series
4-42
4.25 REMOVAL AND INSTALLATION, SUPER SPACE CAB PLASTIC SUN VISOR
When using cleaning agents,
primers, glue removers and glues,
be sure to follow the applicable
safety instructions.
Excess cleaning agent, primer, glue
remover and glue which has not set
must be disposed of as chemical
waste. Glue which has set is not
classified as chemical waste.
Surface condition of the polyester roof
The outside of the roof has a gel coating
(polyester top coat).
Do not apply a finishing coat to the gluing
surface!
Removing the plastic sun visor
1. Remove the plastic sun visor by carefully
cutting the sealant between the polyester
roof and the plastic sun visor.
2. Remove as much of the sealant remnants
as you can from the polyester roof edge.
Pre-treating the plastic sun visor
The pre-treatment described below guarantees
that the entire surface which will come into
contact with the glue will be covered with a
suitable layer of primer.
1. To prevent the sun visor from being fouled
with primer or glue and to prevent damage
due to sanding, tape up the edges of the
area of the sun visor to be glued with thin,
smooth, adhesive tape.
2. Those areas of the plastic sun visor which
are to be glued should be cleaned
beforehand with a non-pilling, clean, white
cloth moistened with the specified cleaning
agent, see ”Technical data” and then lightly
sanded with the specified abrasive, see
”Technical data”.
4
ᓻ 200345
To Next Page
Loading...
Need help?
General
