ALLISON MD 3060 AUTOMATIC GEARBOX
4-6
©
200508
Removal and installation
8
ΛΦ45/55 series
3
Removing oil filters
1. Remove the attachment bolts from the filter
covers (2) and remove the filter covers.
Collect the oil that comes out.
2. Remove the oil filters from the oil sump.
3. Remove the various O-rings and the gasket
from the filter covers.
4. Remove any gasket remains from the filter
covers and the contact surfaces.
Installing oil filters
1. Lubricate the new O-rings with clean
gearbox oil and fit the various O-rings on the
filter covers.
Note:
Compare the new O-rings to the old ones to
ensure that the correct O-rings are used.
2. Fit a new gasket on the filter covers.
3. Lubricate the rubber inner ring of the oil filters
with clean gearbox oil and fit the oil filters on
the filter covers.
4. Fit the filter covers together with the oil filters
on the gearbox and tighten the attachment
bolts to the specified torque. See "Technical
data".
5. Check the oil level. See "Inspection and
adjustment".
V300371
2
1
DAF LF Gearboxes and Clutch Service Manual
To Next Page
Loading...
Need help?
General
