TECHNICAL DATA
9-2
©
200508
Prop shafts
0
ΛΦ45/55 series
3
9.2 TIGHTENING TORQUES
The tightening torques stated in this paragraph
are different from the standard tightening torques
stated in the overview of the standard tightening
torques.
The other threaded connections not specified
must therefore be tightened to the torque
mentioned in the overview of standard tightening
torques.
When attachment bolts and nuts are replaced, it
is important that - unless stated otherwise - these
bolts and nuts are of exactly the same length and
property class as those removed.
Drive flange
Spicer intermediate bearing
Spicer universal joint
Spicer suspension bearing
Monotron suspension bearing
M10 attachment bolts 60 Nm
M12 attachment bolts 105 Nm
SPL 39 and SPL 55 central nuts 400 Nm
SPL 70, SPL 100 and SPL 140 central nuts 685 Nm
5
/
16
" attachment bolts, UNF clamping bow, prop
shaft - universal joint 38 Nm
3
/
8
" attachment bolts, UNF clamping bow, prop
shaft - universal joint 70 Nm
M8 attachment bolts, clamping piece, universal
joint circlip SPL 140 38 Nm
Bracket attachment bolts 110 Nm + 30″ angular displacement
M10 bracket attachment bolts 60 Nm
M12 bracket attachment bolts 105 Nm
DAF LF Gearboxes and Clutch Service Manual
To Next Page
Loading...
Need help?
General
