DAF LF55 Series Service Manual

©
200508 5-1
Removal and installation
CLUTCH
ΛΦ45/55 series
3
9
5. REMOVAL AND INSTALLATION
5.1 REMOVAL AND INSTALLATION, CLUTCH SERVO
Hydraulic fluid is toxic and can
therefore have a damaging effect on
your health. Any direct or indirect
physical contact should therefore be
avoided.
As hydraulic fluid is also corrosive it
may damage the paintwork of the
vehicle. Any contact between
hydraulic fluid and paintwork should
therefore be avoided.
Always use new and clean hydraulic
fluid which has been kept in a sealed
container that meets the
specifications. Hydraulic fluid which
has absorbed water (from the
ambient air) may have an adverse
effect on the operation of the clutch
system. Avoid any contact with
mineral oil. Even one drop of mineral
oil in the system will damage the
seals.
Removing clutch servo
1. Remove the air pipe from the clutch servo.
2. Place a container beneath the clutch servo
and remove the fluid pipe. Then plug the
pipe.
Note:
The clutch servo is mounted against the clutch
housing under pre-tension.
3. Remove the attachment nuts from the clutch
servo.
Fitting clutch servo
1. Fit the clutch servo.
Note:
Make sure that the push rod falls into the cup-
shaped recess in the wear indicator. Then tighten
the attachment nuts evenly.
2. Tighten the attachment nuts evenly.
3. Connect the air and fluid pipes.
4. Fill and bleed the clutch system.
}
}
}
V300289
10
DAF LF Gearboxes and Clutch Service Manual

DAF LF55 Series Specifications

General

Brand	DAF
Model	LF55 Series
Category	Trucks
Language	English