EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
5-6
©
200423
Draining and filling
5
ΞΦ95 series
Bleeding by pressurising the fuel tank
To prevent deformation of the fuel
tank, the delivery pressure in the fuel
tank must not exceed 0.4 bar.
1. Remove the fuel tank cap and replace it by a
cap with an adjustable air connection.
Note:
Use a cap (without a vent) that has a
connection for a pressure reducer valve.
2. Pressurise the tank to a maximum of 0.2 bar.
3. Loosen the union nut on the injector.
4. Tighten the union nut to the specified torque,
see "Technical data".
5. Repeat points 1, 2 and 3 for the other
injectors.
Drive and chas sis
i400600
13
04
2
}
i 400237
To Next Page
Loading...
