EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
5-10
©
200423
Draining and filling
5
ΞΦ95 series
Filling the wheel hub
1. Position the wheels in such a way that the oil
drain/filler plug (A) is at the top.
2. Fill the wheel hub with the specified quantity
of oil. See "Technical data".
3. Check the oil level after approx. 5 minutes, it
should reach up to the level check/filler plug.
4. Fit the level check plug (B) and the drain/filler
plug (A) using the special Torx wrench
(DAF no. 1329493) and tighten the plug to
the specified tightening torque. See
"Technical data".
A
A8 00 364
To Next Page
Loading...
